How to Use the ScoutWatch™
— Complete Instructions —

Where to stand: The ScoutWatch is simple to use but your position is important.  Do not stand behind the catcher. You should view the pitch from the 1st or 3rd base side, so that you get a good view of the pitcher’s release and the catcher’s catch.

Use of the buttons: When the pitch is released, press and hold the start button. When the pitch is caught, release the button. The display will show you pitch speed in MPH. If pitch is hit, press and release the start button again to get the runner's time to first base in seconds. Remember, the ScoutWatch needs only a “light” touch…do not “mash” the buttons since the internal switches may be damaged.

To change the battery: Remove the 3 screws on the back-cover, and pry the battery loose.  Slide the new battery (provided) into place and replace the back cover. Check the button functions immediately.

Measuring pitch count & pitch speed: Press the On/Off button and a “1” will appear in the display. This is the pitch count.  Press the top-right button for approximately 1/2 sec. and you will read a 2-digit number.  This is the pitch speed (MPH) from release to catch. The accuracy is dependent on your ability to press on the release and let up on the catch.  With practice, you will get more accurate results. Use TV games to practice. Press this button again when the batter reaches 1st base and you will get his time-down-the-line (or catcher’s throw to 2nd).

Changing modes: To change to another field size simply press the “Reset” button. You can set for Little League, FastPitch 40 or 30, and then back to the default (Pro/HS) mode.  If this button is depressed while powering up, the mode will switch to “Umpire”, and the display will show balls, strikes, and outs, including automatic count-resets when appropriate.  This can be used in lieu of a mechanical “clicker”.

Questions?  Please call us at (800) 474-8243